PLC
S7-200
LED lamps
All products
The 6ES7131-6BF00-0CA0 is a digital input module of the SIMATIC ET 200SP series from Siemens. Here is a detailed description:
- Basic Information
- Product Type Designation: DI 8x24VDC HF, where “HF” stands for High Feature.
- Usable Base Units: BU type A0.
- Color Code: CC01.
- Hardware Functional Status: Above FS07.
- Firmware Version: Upgradable.
- Power Supply Characteristics
- Power Supply Voltage: The rated value is 24V DC, and the allowable range is from 19.2V DC to 28.8V DC. It has reverse polarity protection.
- Sensor Power Supply: There are 8 output terminals, with a minimum output voltage of 19.2V. Each channel and each module have short – circuit protection, and the maximum output current per channel and per module is 700mA.
- Power Loss: The typical value of power loss is 1.5W.
- Digital Input Characteristics
- Number of Digital Inputs: 8.
- Input Type: Sink input (PNP, P – reading), which complies with IEC 61131, type 3.
- Input Voltage: For signal “0”, it is – 30 to +5V; for signal “1”, it is +11 to +30V.
- Input Current: For signal “1”, the typical value is 2.5mA.
- Input Delay: It is parameterizable, with values of 0.05/0.1/0.4/0.8/1.6/3.2/12.8/20ms (plus 30 to 500µs delay related to the wire length).
- Wire Length: The maximum length of shielded wire is 1000m, and the maximum length of unshielded wire is 600m.
- Diagnostic Function
- It has comprehensive diagnostic functions, including power – voltage monitoring, sensor – power – supply monitoring for each channel, wire – break diagnosis for each channel (with an optional circuit to avoid open – circuit diagnosis of a single sensor contact: 25kΩ to 45kΩ), and short – circuit diagnosis for each channel.
- The diagnostic information is readable, and there are diagnostic LEDs, including a green PWR – LED for power – voltage monitoring, green LEDs for channel – status display, red LEDs for channel diagnosis, and a green/red DIAG – LED for module diagnosis.
- Configuration and Communication
- It supports configuration in STEP 7 TIA Portal (since version V13 SP1), STEP 7 (since version V5.5), and PCS 7 (since version V8.1 SP1).
- It also supports PROFIBUS and PROFINET fieldbuses, with the PROFINET version being GSDML V2.3 and the PROFIBUS version being GSD files of revisions 3 and 5 and above.
- Mechanical and Environmental Characteristics
- Dimensions: The width is 15mm, the height is 73mm, and the depth is 58mm.
- Weight: Approximately 28g.
- Operating Temperature: When installed horizontally, it is from – 30°C to 60°C; when installed vertically, it is from – 30°C to 50°C (since FS07, the lower limit is < 0°C).
- Mounting Altitude: The maximum installation altitude is 5000m, but there are restrictions when the installation altitude is greater than 2000m.
Reviews
Clear filtersThere are no reviews yet.