NEW 6ES7132-6BF00-0CA0

Basic Information

• Product Type Designation: DO 8x24VDC/0.5A HF, where “HF” denotes High Feature.
• Usable Base Units: Compatible with BU type A0.
• Color Code: CC02.
• Hardware Functional Status: From FS07 onwards.
• Firmware Version: Upgradable, allowing for future functionality enhancements.

Power Supply Characteristics

• Power Supply Voltage: Rated at 24V DC, with an allowable range of 19.2V DC to 28.8V DC. It includes reverse polarity protection.
• Current Consumption: Maximum current draw from the backplane bus is 45mA (without load).
• Power Loss: Typical power consumption is 1W.

Digital Output Characteristics

• Number of Outputs: 8.
• Output Type: Source output (PNP, P-switching), compliant with IEC 61131, type 3.
• Output Voltage: For signal “1”, minimum 20.4V (at 0.5A load); for signal “0”, maximum 1.5V.
• Output Current: Rated at 0.5A per channel, with a maximum of 0.5A per channel and 4A total for the module.
• Residual Current: Maximum 10µA when in “0” state.
• Load Resistance Range: 48Ω to 100kΩ.
• Switching Delay: From “0” to “1” (turn-on) maximum 100µs; from “1” to “0” (turn-off) maximum 150µs (resistive load).
• Switching Frequency: Maximum 100Hz for resistive loads, 2Hz for inductive loads, and 10Hz for lighting loads.
• Wire Length: Maximum 1000m with shielded cables; maximum 600m with unshielded cables.

Protection and Diagnostic Features

• Protection: Each channel is equipped with short-circuit protection.
• Diagnostics: Offers comprehensive diagnostic capabilities including power supply voltage monitoring, short-circuit detection per channel, and cumulative fault monitoring. Status is indicated via LEDs: green PWR-LED (power), green channel-status LEDs, red channel-diagnostic LEDs, and a green/red DIAG-LED (module diagnostics).

Configuration and Communication

• Supported by configuration tools such as STEP 7 TIA Portal (from version V13 SP1), STEP 7 (from version V5.5), and PCS 7 (from version V8.1 SP1).
• Compatible with PROFIBUS and PROFINET fieldbuses, utilizing GSDML V2.3 (PROFINET) and GSD files of revision 3 and 5 or higher (PROFIBUS).

Mechanical and Environmental Specifications

• Dimensions: 15mm width, 73mm height, 58mm depth.
• Weight: Approximately 30g.
• Operating Temperature: -30°C to 60°C when mounted horizontally; -30°C to 50°C when mounted vertically (with adjusted lower limits for FS07 and later).
• Mounting Altitude: Up to 5000m, with derating requirements for altitudes exceeding 2000m.